CCTV Hard Disk Storage Calculator
Enter the number of cameras, resolution, compression and recording days to see the storage an NVR or DVR needs and the drive sizes that fit.
Storage needed including 10% margin
- Per camera per day0 GB
- All cameras per day0 GB
- Without margin0 TB
- Total recording bandwidth0 Mbps
Drive sizes that fit
Results are approximate. Real bitrate depends on the scene, lighting and camera settings, and rises at night in VBR mode with IR on, so keep the margin. Check the maximum capacity per HDD bay in the recorder datasheet.
How the calculator works
The calculator works from bitrate, the amount of data a camera sends each second. For 24-hour recording, every 1 Mbps equals about 10.8 GB per day. The result is multiplied by the number of cameras and days, reduced by recording hours or motion share, and then a 10% margin is added.
If you do not know the bitrate, the calculator fills in an estimate by resolution and compression at 25 frames per second. Lowering the frame rate does not cut the bitrate by the same ratio, because key frames stay the same, so the calculator reduces it by less than the straight ratio:
| Resolution | H.264 | H.265 | Smart codec |
|---|---|---|---|
| 2MP | 4 | 2 | 1.2 |
| 4MP | 6 | 3 | 1.8 |
| 5MP | 8 | 4 | 2.4 |
| 8MP (4K) | 12 | 6 | 3.6 |
Values are in Mbps and are estimates for common use; the bitrate actually set in the camera or recorder is always the better figure.
Worked example
Eight 2MP cameras on H.265 at 2 Mbps, recording continuously for 30 days: each camera needs about 21.6 GB a day, all eight about 173 GB a day, which is about 5.2 TB for 30 days and about 5.7 TB with margin, so a 6 TB drive fits.
Tips when choosing the hard disk
- Use surveillance drives built for continuous operation, such as WD Purple or Seagate SkyHawk.
- Check the number of HDD bays in the recorder and the maximum capacity per bay before buying.
- The recorder overwrites the oldest footage automatically when the disk is full, so the number of days is what sets the size.
- Motion recording saves space in quiet places, but it does not suit busy entrances or sites that need continuous footage.
Related products from Do Link
Frequently asked questions
How do I calculate hard disk size for CCTV?
Daily storage per camera in GB is roughly the bitrate in Mbps multiplied by 10.8 for 24-hour recording. Multiply by the number of cameras and days, then add about 10% margin.
How many TB do 8 cameras at 2MP need for a month?
With H.265 at about 2 Mbps per camera and continuous recording, you need about 5.2 TB for 30 days, or about 5.7 TB with margin, so a 6 TB drive fits.
Does H.265 really save space?
Yes. It usually needs about half the bitrate of H.264 for similar quality, and smart codecs such as H.265+ or Ultra 265 cut it further in low-motion scenes. The calculator figures are approximate; the exact figure is the bitrate set in the camera.
Why does the drive show less capacity than its label?
Manufacturers count a terabyte as 1000 GB, while recorders and computers display capacity in base 1024, so a 4 TB drive shows about 3.6 TB. The calculator uses the same base 1000 as the manufacturers, so you can compare its result directly with the drive label.
Which hard disk suits CCTV?
Choose surveillance drives built for continuous operation, such as WD Purple or Seagate SkyHawk, and check the maximum capacity each HDD bay supports in the recorder datasheet.
Does motion recording reduce the storage needed?
Yes, because the recorder only records when there is motion. The real saving depends on the site: a busy entrance is close to continuous recording, while a warehouse closed at night saves a lot.
Need help designing your project?
Do Link engineers help you choose equipment and work out quantities, and they design and execute CCTV, network, intercom and access control projects, with wholesale and project prices for contractors, technicians, companies and finishing companies.